The RepWinder: A spool rewinder solution! (Hardware Only)
The Repbox Seal Kit is a must have addon for the Repbox V2 that seal. Not only does it ensure you keep excess moisture and dust away from your filaments but it also includes a locking latch.
- Additional information
- Reviews (0)
NOTE: COMPATIBLE WITH SPOOLS WITH A 2inch ARBOR UP TO ~75mm WIDE. WHILE WE HAVE DONE OUR BEST TO PROVIDE AS MUCH COMPATIBILITY AS POSSIBLE, THERE ARE NO STANDARDS FOR SPOOLS SO YOU MAY NEED TO DESIGN SPACERS/ENCAPS THAT FIT YOUR PARTICULAR SPOOLS. ONLY THE GENERIC/PRUSAMENT MOUNT ARE PROVIDED IN PRINTED PARTS KIT.
OPTIONAL SPACERS AND END CAP STLS AVAILABLE FOR DOWNLOAD HERE. ADDITIONAL COMMUNITY DEVELOPED SPOOL MOUNTS WILL BE RELEASED AS AVAILABLE.
The hardware kit includes the following to make 5x Repwinder
- 3″ x 3/16 Cotter Pin Axle(s)
- Tape Measure(s) for Main Spring Cartridge(s) (Found inside 10ft/3m Tape Measures)
- Clutch Spring(s) 18mm Diameter x 18mm Free Length
- Nylon Bushings (act as bearings)
- M3 Square Nut(s)
- M3 x 3mm Set Screw(s)
- 2 M3 x 16mm Button Head Screw(s) for Optional Crank
FULLY REPBOX2 COMPATIBLE:
WALL MOUNTABLE USING THE FOLLOWING KIT:
|Dimensions||30 × 20 × 5 cm|